MACHINERY

Pulse dust makes harvest hygiene a must

Operators need to be cautious of fire risks when harvesting pulses in dusty conditions.

Staff writer
 Pulse Australia is reminding growers to be aware of an increased risk of fires when harvesting pulses. Image courtesy Pulse Australia.

Pulse Australia is reminding growers to be aware of an increased risk of fires when harvesting pulses. Image courtesy Pulse Australia.

Many pulse crops come with an increased fire risk because of certain characteristics of the residues and dust generated from the crop.

Chickpeas have high concentrations of malic and oxalic acid exuded from the fine leaf hairs, which causes the residues to stick together inside the harvester. This can lead to a build up of fine particles that are extremely combustible.

Lentils also have a very fine residue that can stick to the harvester and to dust particles. In addition, both these crops have pods very close to the ground so the header front is working virtually on the ground and can easily strike a rock, causing sparks to ignite the fine powder.

Peas, lupins and faba beans also have fine residue that powders easily and creates higher risk of ignition.

Pulse Australia and ACH recommend the best fire protection approach is to increase risk protection measures. And machine maintenance and machine hygiene are the two biggest factors to decrease fire risk.

Other risk-decreasing factors include initial paddock preparation to clear rocks and sticks and rolling the paddock to give an even, flat surface that is suitable for harvesting low to the ground.

Also, only operate harvesters when the conditions are favourable under the Grain Harvesting Code of Practice FDI 35.

Other tips include:
* Clean all cereal straw out of and off, every surface of the machine before starting in pulse crops. Pulse crop residue may smoulder. It's the cereal straw that will make the fire get out of control very quickly.
* Check under guards and covers for build up of dust and chaff.
* Check all knife guards and knife sections for damage or misalignment. Bent guards will cause heat build-up.
* Check bearings and moving parts for hot spots (use a hand held digital thermometer)
* Check the electrical system for worn cables (especially for rodent damage)
* Fix all fuel and hydraulic leaks.
* Use the battery isolation switch when the header is not in use.
* Locate fire-fighting gear close to the paddock. A small garden water sprayer located in the cabin can help extinguish small fires.
* Have a bare earth 'safe' area to park machinery for servicing.
* Train all staff in using firefighting equipment.

More details and tips to help reduce harvester fire risk can be found here: https://bit.ly/3kWMYDZ

A growing series of reports, each focused on a key discussion point for the farming sector, brought to you by the Kondinin team.

A growing series of reports, each focused on a key discussion point for the farming sector, brought to you by the Kondinin team.

editions

Research Report: Field Days Wrap (November 2024)

Kondinin Group's research team has the low down on the latest gear that was on show at various field days held around the country in the past few months.

editions

Research Report: Trailing Sheep Feeders (October 2024)

Trailing sheep feeders are on the menu for Kondinin Group's October Research Report with nine popular models covered.

editions

Research Report: Livestock Management Software (September 2024)

Kondinin Group's September Research Report looks at a range of livestock management software platforms which can make life a lot easier when it comes to efficient sheep and cattle production.

editions

Research Report: Grain Storage (August 2024)

This month's Research Report from Kondinin Group looks at the benefits and challenges associated with ground level storage with a focus on growers who have done it successfully.